Rokoat™ WoodGuard is an easy to apply coating that nourishes and protects all kinds of exterior woods and timbers. With its revolutionary formula that penetrates deep into timber leaving an impermeable and highly hydrophobic protective layer, Rokoat™ WoodGuard is ceramic based, protecting timber surfaces from sun damage, UV, rain, ice, salt water & oils including suntan lotion. Rokoat™ WoodGuard leaves a natural wet look finish to the surface it is applied to and will provide years of quality protection. Rokoat™ WoodGuard will not affect mastic and other polyurethane caulking sealants. Use simply and easily on teak decks, furniture, bars and untreated frameworks.

Typical Applications

Teak decking, timber decking, bars and work ares, outdoor timber furniture

  • 1L protects up to 40m2 !
  • All-in-one coating, nourishes and protects wood & timber
  • Creates a hydrophobic barrier against water & staining
  • Protects against UV, salt water, sunscreens, liquids
  • Reduces cleaning, scrubbing and maintenance
  • Leaves a clear, natural finish
  • Over 1 year of protection
Surface Preparation

  • Clean surfaces to be treated thoroughly.
  • Ensure all oils, dirt and adhesive film remnants are removed.
  • Ensure the surface is dust free and thoroughly dry.
  • Mastic does not need to be protected from Rokoat WoodGuard.
  • Rokoat WoodGuard will stain fabric surfaces.
  • Remove these from timber furniture before application.

Application Methodolgy

Brush & Sponge

  • Brush and Sponge application will apply Rokoat WoodGuard at an average thickness of 5 – 10 μm.
  • Apply this product using a clean soft brush or sponge in straight linear motions working with the grain (if possible).
  • Work from corners, edges and difficult areas into easier open surface spaces.
  • Apply liberally like a tint. Do not pool the coating. Protection is built through layering the coats rather than large quantities each time.
  • Leave the product to dry for 15-25 minutes. Once dry additional coats can be applied.
  • Repeat as necessary.

Spray

  • Using a nozzle of 1.5mm will apply Rokoat WoodGuard at an average thickness of 2 – 5 μm.
  • Load hopper with Rokoat WoodGuard.
  • Start at a corner and working sideways in straight linear motions with the grain, move from difficult areas to easier open surface spaces.
  • Apply liberally like a tint. Do not pool the coating. Protection is built through layering the coats rather than large quantities each time.
  • Leave this product to dry for 15-25 minutes. Once dry additional coats can be applied.
  • Repeat as necessary.

NOTE : It is strongly recommended to test your preferred application method before commencing on your desired surface. Rokoat WoodGuard will stain fabrics.

  • Usable ambient cured properties are obtained 24 hours after application.
  • Leave 4 hours (dependant on temperate) before walking on surface.
  • Water submersible or maximum product properties are achieved after 5 days.
  • Older, more porous wood may require additional coats.
  • A minimum 3rd coat application is recommended for high use areas.
  • Once a natural ‘wet look’ is achieved no further coats are required.
  • Rokoat TechShield Bonding Primer can also be used to adhere stickers, vinyl and decal.

Downloads

Download Product Data Sheet
Download Application Guide